How to disable TLS 1.0 in Windows 10

TLS or Transport Layer Security is a Cryptographic Protocol and is used to get PC networking. However, we have seen the advancement of this protocol and after such countless iterations using TSL 1.0 for security is anything but a smart thought. In this article, we are going to perceive how to disable TLS 1.0 in Windows 10.

Disable TLS 1.0 in Windows 10

The majority of the programs don’t uphold TLS 1.0, they usually support TLS 1.2. And there are clear reasons for the same as TLS 1.0 isn’t extremely gotten. Thus, since it isn’t used, disabling the protocol is a savvy decision and in this post, we are going to perceive how to do likewise.

These are the two methods by which you can disable TLS 1.0 in Windows 10

  • By Internet Properties
  • By Registry Editor

Allow us to talk about them in detail.

1] By Internet Properties

The easiest way to disable TLS 1.0 is via Internet Properties. Along these lines, to disable this protocol follow the given steps.

  1. Search out Internet Options from the Start Menu.
  2. Go to the Advanced tab.
  3. Look down a piece and from the Security segment, untick Use TLS 1.0, and click Apply > Ok.

Also see: Fix ‘Setup incomplete because of a metered connection error’ Windows 10

Along these lines, you have disabled TLS 1.0 on your system.

2] By Registry Editor

To disable the protocol by Registry Editor, launch Registry Editor from the Start Menu and navigate to the following location:


Right-click on Protocol, select New > Key and name it “TLS 1.0″. Now, right-click on TLS 1.0, select New > Key, and name it “Customer”.

Right-click on Client, select New > DWORD (32-bit) Value, and name it “Enabled”. Now, since the default value of Enabled is 0, TLS 1.0 will be disabled. However, if you want to enable the protocol, simply change the Value data to 1.

Along these lines, you have disabled TLS 1.0 on your PC.

Leave a Comment

Your email address will not be published. Required fields are marked *