Fix Network Properties Unexpected Errors Occurred

At some point, a user has to configure his network properties. As Windows 10 is capable of providing tons of beneficial services to its users, changing networking settings is just one of them. But sometimes when your OS gets updated, it starts to work inappropriately.

For instance, many Windows users have complained about not bieng able to access network properties as expected. So if you are one of such consumer, I’m here to help. I’ll tell exactly what you need to Fix Network Properties Unexpected Errors Occurred. This way, you’ll be allowed to make further customizations as expected.


3 Ways To Fix Network Properties Unexpected Errors Occurred

Reinstall Network Adapter’s Drivers

Fix Network Properties Unexpected Errors Occurred

  • Launch Device Manager on Windows.
    1. Open it by pressing Windows + R key and then executing “devmgmt.msc” from the Run box.
    2. Use the Cortana Search bar to open this utility.
  • Now locate and expand the “Network Adapters” tab.
  • Right-click on your desired network adapter and select “Uninstall Device”
  • Click on the “Uninstall” button to confirm your action.
  • When you are notified of its uninstallation, click on “Action” from the menu bar.
  • Select “Scan for hardware changes”
  • Wait a while until your operating system reinstalls the drivers.
  • After its done, check if the problem is solved or not.

Update Network Adapter’s Driver

Fix Network Properties Unexpected Errors Occurred

  • Navigate to Device Manager by implementing the same method provided in the first step.
  • Right-click on your Network Adapter and select “Update Driver”
  • On the next window, click on “Search automatically for updated driver software”
  • If you are notified of driver update, allow Windows to install it.
  • Thereafter, reboot your PC.

Disable TCP/IPv6

Fix Network Properties Unexpected Errors Occurred

  • Launch Control Panel through the search bar.
  • Go to Network and Internet >> Network and Sharing Center
  • From the left-side menu, click on “Change Adapter Settings”
  • Right-click on “Ethernet” and select “Properties”
  • Under the “Networking” tab, uncheck the “Internet Protocol Version 6 (TCP/IPv6)” box.
  • Click on the “Ok” button and close all other tabs.
  • Restart PC to use to save changes properly.

Change DNS Address

Fix Network Properties Unexpected Errors Occurred

  • Again Launch “Change Adapter Settings”
  • Navigate to the properties of your Ethernet.
  • Select “Internet Protocol Version 4 (TCP/IPv4)” and click on “Properties”
  • Under “General”, select “Use the following DNS server addresses” bullet.
  • Now Set as the “Preferred DNS server”
  • Enter in “Alternate DNS server”
  • Afterward, click on the “Ok” button.

That’s all, keep visiting WindowsBoy for more.

Leave a Comment