Table of Contents
Pen drives are used to transfer data from one device to another. Either you are a student or an employee at the office, there comes a time when you have to transfer data via external storage devices. In such category storage disks, SSD comes handy for file transferring purposes. Because they can contain GBs or TBs of data.
So what if your SSD drive becomes corrupted? Would you rather use USB drives or find a fix to make it work again? If you want to make your SSD drive work like before, then you need to format it. But you may encounter some issues while formatting SSD drive on Windows 10. So I’m here to help you find a fix of How To Format SSD Drive on Windows 10. You’ll find my article beneficial for solving this critical issue.
Formating SSD Drive on Windows 10
There are two basic methods that you need to follow to Format SSD Drive on Windows 10. I’ve presented both of them in my guide here. Through my method, you can also convert NTFS formatted SSD drive to FAT32 or exFAT as well. So try to follow & perform all of the steps, I’ve drafted for you.
Removing Write Protection
There’s a chance that your SSD Drive is write-protected. If it is, then you can’t format it whenever you want to. Good thing is that you can remove such privileges by following the steps drafted below:
- Open Run dialogue box by pressing Windows + R button.
- Enter diskpart in the box and click on the Ok button.
- Now, you are required to execute the following commands one by one.
list disk select disk (type your SSD drive name here) attributes disk clear readonly
- Now you need to wait a while and let diskpart complete the process.
- When it is done, execute the Exit command in it.
- Now see if your SSD drive is formatting or not.
Using DiskPart for Formatting SSD Drive
Before going through another step, you need to press Windows + X button and open the disk management. Here, you will see the list of disk drives that are available and connected with your PC. After you are done locating the SSD drive, you need to perform the following steps:
- Open DiskPart again on Windows 10.
- Now run the following commands individually in the DiskPart command interface.
list disk select disk X (x = SSD drive) clean create partition primary format fs=ntfs quick assign letter=m (m = letter assigned to SSD)
- When done, your SSD Drive will start to format and will not provide an error saying SSD Drive won’t format on Windows 10.
- Also, you can change the format type from NTFS to FAT32 or exFAT, if you want to.
That’s all, keep visiting Windowsboy for more.